<strong>2024 aluminum alloy,</strong> the main alloying elements are copper and magnesium.<br> <strong>Applications</strong> where high strength but low weight ratio is required, and good fatigue strength.<br> <strong>Not weldable,</strong> general processing performance. <br> <strong>Because</strong> of poor corrosion resistance, aluminum-zinc splints are often used as protection, which results in reduced fatigue strength.

<strong>The main alloying elements in 6061</strong> alloy are magnesium and silicon, which have moderate strength, good corrosion resistance, weldability and good oxidation effect. <br> Widely used in various industrial structural parts requiring a certain strength and high antibiotic corrosion, its main chemical composition: Cu:0.15-0.4; Si: 0.4-0.8; Fe: 0.7 -; Mn: 0.15; Mg: 0.8-1.2; Zinc: 0.25; Cr: 0.04-0.35; Ti: 0.15 -; 6061 aluminum plate its state T6 and T651 difference is that in general, T6 internal stress will be relatively large, processing will be deformed, the most suitable for processing state should be T651, he is on the basis of T6 tensile, eliminate internal stress.

<strong>6082</strong> is a heat-treatable alloy with good formability, weldability, machinability and corrosion resistance. <br> <strong>It also has </strong> moderate strength and can maintain good operability after annealing. <br> <strong>It is mainly used</strong> in mechanical structure, including bars, plates, pipes and profiles.

<strong>Thickness: </strong>0.15-150mm<br> <strong>Port of Destination: </strong>Any port you like<br> <strong>Aluminium Sheets </strong>with high strength is mainly used make Fire Engine Side Panel and Dump Truck Floor in industry.<br> <strong>Because of its good</strong> energy absorption ability in collision experiment, engine mount, side impact beam, engine splash shield, ABS, airbag part, etc.